Repair Guide: How to Replace Brake Pads on a Ford Mustang
Introduction
This guide will walk you through the process of replacing the brake pads on your Ford Mustang. Please note that it's always important to consult your vehicle's manual and a certified mechanic for any major repairs or modifications.
Tools Required:
- Socket/ratchet set
- Wrench
- Brake caliper compress tool
- C-clamp
- New brake pads
Steps:
-
Set up your car:
Park your car on a flat surface, apply the parking brake, and open the hood.
-
Remove the wheels:
Use an appropriate socket to loosen the lug nuts on each wheel before raising the car with a jack. Then remove the nuts and take off the wheels.
-
Remove the caliper:
Remove the bolts holding the brake caliper in place and slide it off the brake disc. Be careful not to strain the brake line.
-
Remove the old brake pads:
Pull the old brake pads out of the caliper. They may require a little force if they are worn thin.
-
Install new brake pads:
Apply brake grease to the back of the new brake pads and slide them into the caliper.
-
Re-install the caliper:
Slide the caliper with the new brake pads back over the brake disc and bolt it back into position.
-
Re-install the wheels:
Put the wheels back on the car and hand-tighten the lug nuts. Lower the car, then tighten the lug nuts with a wrench in a star pattern.
-
Test your brakes:
Before driving, press the brake pedal a few times to ensure the pad is making proper contact with the disc.
Conclusion
Congratulations! You've successfully replaced your Ford Mustang's brake pads. Remember, safety is paramount when working on your vehicle, so always consult a professional if in doubt.